The use of acetone is also a very effective means of removing casting resin from the skin. Once the resin is softened it can be easily removed.
Put the vinegar on a cloth and soak the area to be cleaned on your skin with it. This agent even helps when the resin is already cured. Vinegar is a very effective remedy if some epoxy resin has accidentally landed on your skin. Wear gloves to protect against burns and a respirator to prevent inhalation of the vapors generated by the heat. We recommend that only small sections of the resin to be removed are heated at a time and then removed.Īs always when working with epoxy resin, your health should be your first priority. Hot air guns with temperature control have proven to be effective in this procedure, as epoxy resins usually soften from around 200 ° C. The dried resin is softened by the hot air and can then be removed mechanically, e.g. When using methylated spirits, however, note that it is extremely flammable.įully cured epoxy can be extremely stubborn to remove, but a heat gun is a very useful tool help with this. The effect is practically the same and the spirit can be used for many other purposes. Tip: A cheap alternative to the expensive pure alcohol is methylated spirits. If the casting resin is already completely dry, the affected area must first be softened with paint thinner before treatment with ethanol. To do this, a cloth is soaked in ethanol and the area to be treated is then briefly wiped clean. If the epoxy resin is not yet fully cured, it can be removed very easily from the corresponding surface with denatured alcohol. However, this method is more suitable for small spillages on wood or plastic.Ī solution of denatured alcohol and paint thinner, a so-called universal thinner, is also suitable for removing resin residues from surfaces. If some epoxy has accidentally been applied to a surface, it can be effectively dissolved when dry with a special adhesive remover. However, there are still some methods you can use to remove the casting resin after it has cured. If the resin is already completely dry, removal is much more difficult. Epoxy can also be removed very well with vinegar or acetone if it has not yet dried through.
The removal of not yet completely cured epoxy resin is of course much easier than if the material is already completely dry.įor this purpose, the use of isopropyl alcohol (also known as isopropanol) is the most suitable option. Removal of not completely hardened Casting Resin
3.3 Citrus-based waterless Hand Cleaner.3 Removal of Resin residues on the Skin.2 Removal of fully cured Epoxy on Surfaces.1 Removal of not completely hardened Casting Resin.